U-Weld Spindle Kit with Heim Joints

This kits comes with the option of offset or even spindle shaft length. The kit contains everything you need to bolt to your spindle plate.

Offset Spindle Set: The caster blocks have 2 holes, that are 2-1/2" apart. The heim hole is 1/2" and the bottom hole is 3/8". If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16" and 3-1/4".

Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2" apart. The heim hole is 1/2" and the bottom hole is 3/8". If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 3-1/4"

Long Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2" apart. The heim hole is 1/2" and the bottom hole is 3/8". If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16"

Included:

• (2) 1/2'' Male Tie Rod End (Right Hand Thread)
  
• (2) Replacement Bearing for Heim in Castle Block
  
• (2) Aluminum Caster Block
  
• (2) 1/2 x 4-3/8" Kingpin Bolt
  
• (2) 1/2'' Castle Nut (1/2-20)
  
• (2) Reusable Cotter Pins Small
  
• (2) Spindle Arm
  
• (2) Spindle Barrel (1-1/2" Height)
• (4) Spindle Barrel Bearing (1-1/8" OD x 1/2" ID x 3/8" Width)
• (2) Spindle Shaft (see options)
  
• (2) 5/8-18 Lock Nut
• (2) 1/2-20 Lock Nut
• (2) 3/8 x 1" FHCS Bolt
• (1) King Pin Washer Kit