Carburetor / Intake Support Brace for Briggs Animal Engine

This a bracket used to support the carburetor on a Briggs Animal engine.

Instructions:

1. Mount the carb brace to the out board end of the intake manifold on the engine side (not the carb side). 
   
2. Carefully twist and bend the brace to sit against the blower housing.
   
3. Drill a 13/64" hole through the brace and blower housing.
   
4. Remove the brace and tap the hole in the blower housing witha 1/4" x 20 tap. 
   
5. Drill the hole in the brace to 9/32" for bolt clearance. 
   
6. Mount the brace to the manifold and blower housing using blue locktite on the blower housing bolt.