Header Pipe for Briggs and Tecumseh (some) Engines

Header Pipe for Briggs and Tecumseh (some) Engines

Part Number:300564
Availability:In Stock
Location6500-08, S100-04
Your Price: $24.45

This header / exhaust pipe works with Briggs engines, and some Tecumseh. Check the bolt hole spread on your Tecumseh engine before purchasing.

  • 1" OD tubing
  • 1-3/16" long angle cut tip
  • The overall length for the header pipe is approximately 13" long
  • Hole spread of 1-9/16"

 

3 Stars
Good product keep (SOME) in mind
Its a very well put together exhaust, flange appears to bolt right up. At a later date I found that the holes are just a little off, enough to not be able to use it. Also the exhaust comes too close to the carb and needed to be turned in a different direction. In the end I had to cut off the old flange, make another one and weld it on at a different angle. Tecumseh OHH50-68078F
Did you find this helpful?  3 of 3 Found Helpful
Reviewed by:  from Florida. on 6/22/2014
3/5

Related Items

Recently Viewed Items